// PC GAMER — GAMING
'Where is Nvidia? Call Nvidia, guys': Meltgate be damned, modders discover RTX 5090 can use 8-pin connectors after all
When you purchase through links on our site, we may earn an affiliate commission. Here’s how it works.
Ah yes, melty cables. We've been dealing with them ever since the RTX 4090 pushed the 16-pin 12VHPWR connector (now the 12V-2x6 connector) to its limits. Since then, we've heard of numerous cases of melting GPU connectors—check out Uniko's Hardware on X for many examples—and plenty of attempts at dealing with them.
Now, some modders have said 'screw it' to the new 12V-2x6 design, instead modding an RTX 5090 to run on standard 8-pin connectors (via Wccftech). The modders at TecLab fitted three 8-pin connectors to the back of the PCB using "copper plates, cut by hand", and hooked these up to the front via 24 cables (3x sets of 8).
Once everything was also unlocked to operate at higher power levels, the graphics card was put to the test. And while this was just one batch of tests with one card (and don't try this at home, folks) the results were fantastic.
Even before pushing it as far as it eventually goes, the modders were thrilled with the results (machine translated): "It's getting warmer. It's still colder than a 12VHPWR connector. It's colder than the original connector, guys. Where is Nvidia? Call Nvidia, guys. Put the raw footage out there for people to see, otherwise they'll think it's a lie. This looks like a lie."
Don't worry, TecLab, we've got you. You can see the full footage below.
They even manage to get the GPU running over 3,300 MHz in Port Royal benchmark with just two 8-pin cables, showing that a three-cable setup isn't necessary. (For reference, the stock RTX 5090 boost clock is around 2,400 MHz.) And when it's running at a slightly lower clock speed than this the cables stay very cool.
This is especially important because one of the reasons why the 12VHPWR cable was deemed necessary by many is because it apparently helped prevent having too many standard 8-pin cables connected. But having said that, I'm currently looking at an RX 9070 XT with 3x 8-pin cables and it doesn't seem too overboard to my eyes.
Keep up to date with the most important stories and the best deals, as picked by the PC Gamer team.
Even with one cable, TecLab gets it running at over 3,200 MHz. Though that single cable does hit 91–92 °C, there's still no melting to be seen.